Aluminum Stock, Ends machined on an angle to fit Win. M-70
Aluminum Pillar Bedding Stock with ends
machined on an Angle to fit Winchester M-70.
Two 4" long pieces of 1/2" OD X .260 ID 6061 T-6 aluminum pillar bedding stock.
By leaving angled ends intact, and parting off in the middle, you will have 4 custom length
pillars, each with one end square to match the flat bottom of the receiver, with the other end on the correct angle to match
the trigger guard at the rear, and the hinge plate at the front. These 4 pillars will bed 2 rifles.
We have recently added a center punch mark, to the lower end of each pillar. When installing these pillars in epoxy
face these dots forward. This will orient the angled lower end of these pillars in the correct direction to match the
angle of the trigger guard, and the hinge plate.
No liability is expressed or implied for
damage or injury which may result from the improper installation or use of this product.
Item #507
|
